Kewtech KEWEVA EV Charge Point Testing Adaptor

Kewtech KEWEVA EV Charge Point Testing Adaptor

The Kewtech KEWEVA EV Charge Point Testing Adaptor is designed to enable the testing of EV charging points. It works with any MFT with EV charging point testing capabilities and features automatic single dial operation for ease of use. The adaptor has direct low resistance connections for highly accurate results and uses standard 4 mm connectors rated at 10 A for testing purposes.

It is suitable for both single and three phase charging equipment. The adaptor is supplied with a durable carry case and is the smallest in its class. Red LEDs indicate live status per phase, and a single rotary dial controls the CP status simulation (standby, ready, and charging). A separate RED LED indicates when voltage is applied to output connectors.

The adaptor features an auto check of the 1 kHz control pilot signal, eliminating the need for an oscilloscope. It incorporates an IEC 62196-2 type 2 connector for EV charging units and has LED indication of phases. The Type 2 male connector is used for EVSE connection.

Features

• Enables testing of EV charging points
• Works with any MFT with EV charging point testing capabilities
• No awkward cable to negotiate when testing – plugs straight into the charging unit
• Automatic single dial operation for ease of use
• Direct low resistance connections for highly accurate results
• Uses standard 4 mm connectors rated at 10 A for testing purposes
• Suitable for single & three phase charging equipment
• Supplied with durable carry case
• Smallest in class
• Red LEDs indicate live status per phase
• Single rotary dial controls the CP status simulation: standby, ready & charging
• Separate RED LED indicates when voltage is applied to output connectors
• Auto check of 1 kHz control pilot signal - no oscilloscope required
• Incorporates an IEC 62196-2 type 2 connector for EV charging units
• LED indication of Phases
• Type 2 male connector for EVSE connection